Danfoss iC2 - Page 280

Group index Group name Parameter
index
Parameter name Parameter
number
Type
5.2.11 Lost Load Detection Delay 2262 uint16
5.2.16 Watchdog Response 804 enum
5.2.17 Watchdog Delay 803 uint16
5.4 Operation Mode
5.4.1 Application Selection 16 enum
5.4.2 Operation Mode 100 enum
5.4.3 Motor Control Principle 101 enum
5.5 Control
5.5.1 General Setting
5.5.1.1 Control Place Selection 801 enum
5.5.1.2 Control Source 802 enum
5.5.1.6 Configurable Status Word STW 813 enum
5.5.1.7 Configurable Control Word CTW 814 enum
5.5.1.10 Operating State at Power-up 4 enum
5.5.1.15 [REM/LOC] Button 46 enum
5.5.1.16 [Off/Reset] Button 44 enum
5.5.2 Digital/Bus
5.5.2.1 Coasting Select 850 enum
5.5.2.2 Quick Stop Select 851 enum
5.5.2.3 DC Brake Select 852 enum
5.5.2.4 Start Select 853 enum
5.5.2.5 Reversing Select 854 enum
5.5.2.6 Set-up Select 855 enum
5.5.2.7 Preset Reference Select 856 enum
5.5.3 Reference
5.5.3.1 Reference Range 300 enum
5.5.3.2 Reference/Feedback Unit 301 enum
5.5.3.3 Reference Maximum 303 int32
5.5.3.4 Reference Minimum 302 int32
5.5.3.5 Reference Function 304 enum
5.5.3.6 Reference Site 313 enum
5.5.3.7 Reference 1 Source 315 enum
5.5.3.8 Reference 2 Source 316 enum
280 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters