Application Guide | iC2-Micro Frequency Converters
6.2.2 Function Codes Supported by Modbus RTU 103
6.2.3 Modbus Exception Codes 103
7 Parameter Descriptions
7.1 Reading the Parameter Table 105
7.1.1 Understanding Parameter Types 105
7.1.2 Understanding Data Types 105
7.1.3 Understanding Access Types 106
7.2 Grid (Menu Index 1) 106
7.2.1 Grid Settings (Menu Index 1.2) 106
7.2.2 Grid Protection (Menu Index 1.3) 107
7.3 Power Conversion & DC-link (Menu Index 2) 108
7.3.1 Status (Menu Index 2.1) 108
7.3.2 Protection (Menu Index 2.3) 109
7.3.3 Modulation (Menu Index 2.4) 115
7.3.4 DC-Link Control (Menu Index 2.5) 117
7.3.5 Output Current Limit (Menu Index 2.7) 118
7.4 Filters & Brake Chopper (Menu Index 3) 119
7.4.1 Status (Menu Index 3.1) 119
7.4.2 Brake Chopper (Menu Index 3.2) 119
7.4.3 Brake Resistor (Menu Index 3.3) 120
7.5 Motor (Menu Index 4) 121
7.5.1 Status (Menu Index 4.1) 121
7.5.2 Motor Data (Menu Index 4.2) 123
7.5.2.1 General Settings (Menu Index 4.2.1) 123
7.5.2.2 Nameplate Data (Menu Index 4.2.2) 125
7.5.2.3 Async. Induction Motor (Menu Index 4.2.3) 126
7.5.2.4 Permanent Magnet Motor (Menu Index 4.2.4) 127
7.5.3 Motor Control (Menu Index 4.4) 129
7.5.3.1 General Settings (Menu Index 4.4.1) 129
7.5.3.2 AC-Brake (Menu Index 4.4.2) 130
7.5.3.3 U/f Curve (Menu Index 4.4.3) 131
7.5.3.4 Dependent Setting (Menu Index 4.4.4) 132
7.5.3.5 Dead Time Compensation (Menu Index 4.4.4.5) 135
7.5.4 Protection (Menu Index 4.6) 136
7.6 Application (Menu Index 5) 142
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 | 7
To Next Page
Loading...
