Danfoss VLT Programming Guide

E
End Of Curve 210
End Of Curve Delay 22-51 211
End Of Curve Function 22-50 210
End-of-timeout Function 8-05 103
Energy Cost 23-81 231
Energy Log 223, 226
Energy Log Resolution 23-50 225
Energy Optimising 152
Energy Savings 23-83 231
Environment 152
Estimated Cycle Time 8-34 106
Etr 165
Example Of Changing Parameter Data 21
Ext. 1 Dif. Gain Limit 21-24 195
Ext. 1 Differentation Time 21-23 194
Ext. 1 Feedback Source 21-14 193
[Ext. 1 Feedback Unit] 21-18 194
Ext. 1 Integral Time 21-22 194
Ext. 1 Maximum Reference 21-12 192
Ext. 1 Minimum Reference 21-11 192
Ext. 1 Normal/inverse Control 21-20 194
[Ext. 1 Output %] 21-19 194
Ext. 1 Proportional Gain 21-21 194
Ext. 1 Ref./feedback Unit 21-10 191
Ext. 1 Reference Source 21-13 193
[Ext. 1 Reference Unit] 21-17 193
Ext. 1 Setpoint 21-15 193
Ext. 2 Dif. Gain Limit 21-44 198
Ext. 2 Differentation Time 21-43 198
Ext. 2 Feedback Source 21-34 197
[Ext. 2 Feedback Unit] 21-38 197
Ext. 2 Integral Time 21-42 198
Ext. 2 Maximum Reference 21-32 196
Ext. 2 Minimum Reference 21-31 196
Ext. 2 Normal/inverse Control 21-40 197
[Ext. 2 Output %] 21-39 197
Ext. 2 Proportional Gain 21-41 197
Ext. 2 Ref./feedback Unit 21-30 195
Ext. 2 Reference Source 21-33 196
[Ext. 2 Reference Unit] 21-37 197
Ext. 2 Setpoint 21-35 197
Ext. 3 Dif. Gain Limit 21-64 201
Ext. 3 Differentation Time 21-63 201
Ext. 3 Feedback Source 21-54 200
[Ext. 3 Feedback Unit] 21-58 200
Ext. 3 Integral Time 21-62 201
Ext. 3 Maximum Reference 21-52 199
Ext. 3 Minimum Reference 21-51 199
Ext. 3 Normal/inverse Control 21-60 200
[Ext. 3 Output %] 21-59 200
Ext. 3 Proportional Gain 21-61 200
Ext. 3 Ref./feedback Unit 21-50 198
Ext. 3 Reference Source 21-53 199
[Ext. 3 Reference Unit] 21-57 200
Ext. 3 Setpoint 21-55 200
Ext. Status Word 16-94 171
Ext. Status Word 2 16-95 171
Extended Cl Autotuning 189
Extended Status Word 269
Extended Status Word 2 269
External Interlock Delay 22-00 201
External Reference 16-50 166
VLT
®
HVAC Drive Programming Guide Index
MG.11.C9.02 - VLT
®
is a registered Danfoss trademark 305

Danfoss VLT Specifications

General

Frequency	50/60 Hz
Enclosure	IP20, IP21, IP55, IP66
Series	VLT
Control Technique	Flux Vector Control
Output Voltage	0-Vinput
Control Method	Fieldbus
Communication Interface	PROFIBUS, CANopen
Protection Features	Overload, Overvoltage, Undervoltage, Short Circuit, Ground Fault
Cooling Method	Liquid Cooled
Storage Temperature	-25°C to +70°C
Relative Humidity	5-95% non-condensing
Altitude	Up to 1000m (3280ft) without derating, up to 4000m (13120ft) with derating
Operating Temperature	-10°C to +50°C (14°F to 122°F)