Codabar Enter/Exit Programming Mode
Product Reference Guide
183
Codabar Set Length 2
This feature specifies one of the bar code lengths for Codabar Length Control. Length 2 is the
maximum label length if in Variable Length Mode, or the second fixed length if in Fixed Length
Mode. The length includes the bar code’s start, stop, check and data characters. The length
must include at least one data character.
The length can be set from 3 to 50 characters. A setting of 00 specifies to ignore this length
(only one fixed length). See "Set Length 2" on page 280 for more detailed programming
instructions.
$CCBL2
Select Codabar Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters
To Next Page
Loading...
Need help?
General
Weight and Dimensions
