Wedge Quiet Interval Enter/Exit Programming Mode
Product Reference Guide
41
Wedge Quiet Interval
This option specifies the amount of time to look for keyboard activity before the reader breaks
the keyboard connection in order to transmit data to host. The selectable range for this feature is
from 0 to 990ms in 10ms increments. See "Wedge Quiet Interval" on page 260 for more
detailed programming instructions.
NOTE
This feature applies ONLY to the Keyboard Wedge interface.
$CKBQI
Select Wedge Quiet Interval Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
10 = Quiet Interval of 100 ms
To Next Page
Loading...
