Codablock F Enter/Exit Programming Mode
Product Reference Guide
231
Codablock F Set Length 2
This feature specifies one of the bar code lengths for Codablock F Length Control. Length 2 is
the maximum label length if in Variable Length Mode, or the second fixed length if in Fixed
Length Mode. Length includes the bar code’s check, data, and full-ASCII shift characters. The
length does not include start/stop characters.
The length can be set from 3 to 255 characters. A setting of 00 specifies to ignore this length
(only one fixed length). See "Set Length 2" on page 280 for more detailed programming
instructions.
$CCFL2
Select Codablock F Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
100 = Length 2 is 100 Characters
To Next Page
Loading...
