Customizing Configuration Settings Setup
Product Reference Guide
13
Interface Settings
The reader is typically factory-configured with a set of default features standard to the interface
type you ordered. See
"Interface Selection" on page 9
.
Global Interface Features, starting on page 17
provides settings configurable by all interface types. If
your installation requires you to further customize your reader, you can select other options
through use of the instructions and programming bar codes available in the appropriate section
for your interface.
•
RS-232 Only Interface, starting on page 19
•
RS-232/USB-Com Interfaces, starting on page 25
•
Keyboard Interface, starting on page 35
•
USB-OEM Interface, starting on page 47
Configuring Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
Configuration Using Bar Codes
:
General Features includes programming for scanning, beeper and
LED indicators and other such universal settings.
Reading Parameters
:
Reading Parameters include programming for scanning, beeper and LED
indicators and other universal settings.
Symbologies
:
Includes options concerning the bar code label types (symbologies). These settings
allow you to enable/disable symbologies, set label lengths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232, Keyboard and USB
interfaces by scanning the following label.
Transmit Software Version
RevA
To Next Page
Loading...
