Datalogic Touch 90 pro User Manual

Error Codes
Product Reference Guide 285
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not passed its
automatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the
reader is reset, the sequence will be repeated. The following table describes the LED
flashes/beep codes associated with an error found.
Label Program-
ming Mode Accep-
tance of
Programming
Configuration option(s) have been
successfully programmed via
labels and the reader has exited
Programming Mode.
N/A
Reader sounds one high frequency
beep and 4 low frequency beeps
followed by reset beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned. N/A
Reader sounds two times at low
frequency and current volume.
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
INDICATION DESCRIPTION LED BEEPER
NUMBER OF
LED
FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assistance
2 Interface PCB
5 [Reserved]
6 Digital PCB

Datalogic Touch 90 pro Specifications

General

Scan speed	256 sec/page
Decoding standards	2/5 family, Code 39, Code 32, Code CIP 39, Code 128, EAN128, EAN/UPC, ISBN/ISSN, CODABAR, Code 93, ISBT128, MSI, Plessey, Telepen, Delta IBM, Code 11, Code 49, Code 16K, GS1 Databar
Standard interfaces	USB, RS-232
Input voltage	5 V
Power consumption	150 mA
Dimensions (WxDxH)	175 x 100 x 80 mm

Weight and Dimensions

Weight	195 g