Product Reference Guide
15
Chapter 3
Configuration Using Bar Codes
This and following sections provide programming bar codes to configure your reader by
changing the default settings. For details about additional methods of programming, see
"Customizing Configuration Settings" on page 12.
Configuration Parameters
Once the reader is set up, you can change the default parameters to meet your application needs.
Refer to "Resetting the Product Configuration to Defaults" on page 14 for initial configuration
in order to set the default values and select the interface for your application.
The following configuration parameters are divided into logical groups, making it easy to find
the desired function based on its reference group.
Interface Configuration:
• "RS-232 Only Interface" on page 19
• "RS-232/USB-Com Interfaces" on page 25
• "Keyboard Interface" on page 35
• "USB-OEM Interface" on page 47
Parameters common to all interface applications:
• "Global Prefix/Suffix" on page 54
• "Data Format" on page 53 offers
advanced configuration options for customization of
scanned data output.
• "Reading Parameters" on page 67
control various operating modes and indicators status
functioning.
Symbology-specific parameters:
"Symbologies" on page 87 defines options for all symbologies and provides the programming
bar codes necessary for configuring these features.
NOTE
You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to
Setup, starting on page 5
and
complete the appropriate procedure.
NOTE
You must first enable your reader to read bar codes in order to use this
section. If you have not done this, go to
Setup, starting on page 5
and
complete the appropriate procedure.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
