Enter/Exit Programming Mode Code 93
222
Touch TD1100
Code 93 Set Length 1
This feature specifies one of the bar code lengths for Code 93 Length Control. Length 1 is the
minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length
Mode. Length includes the bar code’s data characters only.
The length can be set from 01 to 50 characters. See "Set Length 1" on page 278 for more
detailed programming instructions.
$CC9L1
Select Code 93 Set Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
01 = Length 1 is 1 Character
To Next Page
Loading...
