Product Reference Guide 287
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of
Table 27
.
The settings in this table are as applied to a standard RS-232 interface. See
Table 1
for a
listing of default exceptions to this list as applied to other interface types. Page references
are also provided for feature descriptions and programming bar codes for each parameter.
A column has also been provided for recording of your preferred default settings for these
same configurable features.
Table 27. Standard Defaults
Parameter Default Your Setting Page Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey
21
USB Suspend Mode
Disable
22
RS-232
Baud Rate
9600
19
Data Bits
8 Data Bits
21
Stop Bits
1 Stop Bit
21
Parity
None
22
Handshaking Control
Disable
23
RS-232/USB-COM
Intercharacter Delay
No Delay
25
Beep On ASCII BEL
Disable
26
Beep On Not on File
Enable
26
ACK Character
‘ACK’
28
NAK Character
‘NAK’
28
ACK NAK Timeout Value
600 ms
29
ACK NAK Retry Count
3 Retries
30
ACK NAK Error Handling
Ignore Errors
Detected
31
Indicate Transmission Failure
Enable
32
To Next Page
Loading...
Need help?
General
Weight and Dimensions
