Intercode Delay Enter/Exit Programming Mode
Product Reference Guide
43
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds. See "Intercode Delay" on page 262 for more detailed
programming instructions.
$CKBID
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
00 = No Wedge Intercode Delay
To Next Page
Loading...
