Enter/Exit Programming Mode USB-OEM Device Usage
48
Touch TD1100
USB-OEM Device Usage
The USB-OEM protocol allows for the reader to be identified as one of two different types of
bar code readers. Depending on what other scanners you may already have connected to a USB-
OEM POS, you may need to change this setting to enable all devices to communicate.
Options are:
• Table Top Scanner
• Handheld Scanner
NOTE
USB-OEM Device Usage = Table Top Scanner
USB-OEM Device Usage = Handheld Scanner
It may be necessary to switch device usage when connecting two
readers/scanners of the same type to a POS system.
USB-OEM Interface Options
This setting provides for an interface specific control mechanism.
Options are:
• Obey — Obey Reader Configuration Host Commands
• Ignore — Ignore Reader Configuration Host Commands
USB-OEM Interface Options = Obey
USB-OEM Interface Options = Ignore
$CIBUT00
$CIBUT01
$CIFO101
$CIFO102
To Next Page
Loading...
