Setup Customizing Configuration Settings
14
Touch TD1100
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved in the
reader, scan the
Restore Custom Default Configuration
bar code below. This will restore the custom
configuration for the currently active interface.
If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can scan the
Restore USA Factory Configuration
bar code or the
Restore EU Factory Configuration
bar code below.
Both labels restore the reader configuration to the factory settings including the interface type.
The USA label restores Label IDs to those historically used in the USA. The EU label restores
Label IDs to those historically used in Europe. The Label ID sets for USA and EU are shown in
the Label ID section of this manual.
The programming section on the following pages lists the factory default settings for each of the
menu commands (indicated by shaded blocks and bold text).
NOTE
Custom defaults are based on the interface type. Configure the reader for the
correct interface before scanning this label.
CAUTION
Scanning either of the “Restore Factory Configuration” commands below will
result in the loss of any custom configuration settings for your device.
Restore Custom Default Configuration
Restore USA Factory Configuration
Restore EU Factory Configuration
To Next Page
Loading...
Need help?
General
Weight and Dimensions
