Datalogic Touch 90 pro

Enter/Exit Programming Mode Sleep Mode Timeout
72 Touch TD1100
Sleep Mode Timeout
Specifies the timeout value for the reader to enter Sleep Mode (a very low power consumption
state).
NOTE
RS-232 interface ONLY.
A reader having a
Scan Mode setting of Object Sense, Stand
Mode, Flashing, or Always On will not enter Sleep Mode. (The
reader is always internally active when in these modes.)
$CSLTO00
Sleep Mode Timeout = Disabled
$CSLTO1E

Sleep Mode Timeout = 30 Seconds
$CSLTO3C

Sleep Mode Timeout = 1 Minute (60 Seconds)
$CSLTO5A

Sleep Mode Timeout = 1 Minute 30 Seconds (90 Sec-
onds)
$CSLTO78

Sleep Mode Timeout = 2 Minutes (120 Seconds)
DEFAULT