References Scanning Features
274
Touch TD1100
Scanning Features
Scan Mode
Selects the scan operating mode for the reader. Selections are:
Trigger Single:
When the trigger is pulled, scanning is activated until one of the following
occurs:
-
Scanning Active Time
has elapsed
- a label has been read
- the trigger is released
This mode is associated with typical handheld reader operation: when the trigger is pulled,
scanning starts and the product scans until the trigger is released, or a label is read, or the
maximum
Scanning Active Time
has elapsed.
Trigger Hold Multiple :
When the trigger is pulled, scanning starts and the product scans until
the trigger is released or
Scanning Active Time
has elapsed. Reading a label does not disable
scanning.
Double Read Timeout
prevents undesired multiple reads of the same label while in this
mode.
Trigger Pulse Multiple:
When the trigger is pulled, continuous scanning is activated until
Scanning Active Time
has elapsed or the trigger has been released and pulled again.
Double Read
Timeout
prevents undesired multiple reads of the same label while in this mode.
Flashing:
The reader flashes
1
on and off regardless of the trigger status. Flash rate is controlled
by
Flash On Time
and
Flash Off Time
. When Flash is ON the reader reads continuously. When
Flash is OFF scanning is deactivated.
Always On:
No trigger pull is required to read a bar code. Scanning is continually on.
Double
Read Timeout
prevents undesired multiple reads of the same label while in this mode.
Stand Mode:
No trigger pull is required to read a bar code. Scanning turns on automatically
when an item is placed in reader's field of view. While in a stand watch state, the reader
illumination LED goes from dim to maximum bright.
1
Controlled by
Flash On Time
.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
