Symbologies References
Product Reference Guide
279
4. Scan the appropriate two digits from the keypad in
Appendix D, Keypad
, that represent the
length setting which was determined in the steps above. Y
ou will hear a two-beep indica-
tion after the last character
NOTE
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
.
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode
.
This completes the procedure. See the table below for examples of how to set this feature.
Table 21. Length 1 Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting
01 Character 07 Characters 52 Characters 74 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 1SETTING for the desired symbology
4
Scan Two Characters From
Appendix D, Keypad
‘0’ and ‘1’ ‘0’ and ‘7’ ‘5’ and ‘2’ ‘7’ AND ‘4’
5 Scan ENTER/EXIT PROGRAMMING MODE
To Next Page
Loading...
