2. Disconnect the slimline MegaRAID cable from the connector on the MegaRAID card.
3. Disconnect the power cable from the dongle cable.
4. Remove the four screws (6-32) that secure the front SATA/SAS hard-drive modules to the flex0 and flex1.
5. Lift and remove the front SATA/SAS module away from the flex0 and flex1.
Installing the front SATA/SAS module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front SATA/SAS module and provide a visual representation of the installation
procedure.
Steps
1. Align the screw holes on the front SATA/SAS module with the screw holes on the flex0 and flex1.
2. Place the front SATA/SAS modules into the slot in the flex0 and flex1.
100
Removing and installing components
To Next Page
Loading...
