Dell Precision 7960 Tower - Removing the Thunderbolt 4 Pcie Card

Steps
1. Align the UltraSpeed Quad card with the expansion-card slot on the system board.
2. Remove the PCIe filler from the PCIe slot on the chassis.
3. Using the alignment post, connect the UltraSpeed Quad card to the connector and press down firmly. Ensure that the
UltraSpeed Quad card is firmly seated.
4. Close the PCIe door.
Next steps
1. Install the air shroud.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Removing the Thunderbolt 4 PCIe card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
Removing and installing components
81