Steps
1. Align and place the front memory-fan in the slot on the air shroud.
2. Route the front memory-fan cable through the routing guide on the air shroud.
3. Connect the front memory-fan cable to the DDR FAN0 dongle plug in the air shroud.
Next steps
1. Install the air shroud.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Removing the rear memory-fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the rear memory-fan and provide a visual representation of the removal procedure.
32
Removing and installing components
To Next Page
Loading...
