About this task
The following images indicate the location of the rear hard-drive bezel and provide a visual representation of the installation
procedure.
Steps
1. Position the rear hard-drive bezel to align the tabs on the bezel with the slots on the chassis.
2. Press the bezel until the tabs clicks into place.
Next steps
1. Follow the procedure in After working inside your computer.
Air shroud
Removing the air shroud
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
The following image indicates the location of the air shroud and provides a visual representation of the removal procedure.
28
Removing and installing components
To Next Page
Loading...
