3. Install the two screws (6-32) to secure the front-NVMe module to the flex1.
4. Connect the thermal-sensor cable and fan-controller cable to the connectors on the power-distribution board.
5. Connect the power cable (P5) and data cable to the connectors on the HSBP board.
NOTE:
● Follow the same procedure to install the front-NVMe module into the flex0.
● The HSBP power dongle-cable is required when both flex0 and flex1 is installed with NVMe module.
Next steps
1. Install the right-side cover.
2. Install the external solid-state drive assembly
3. Follow the procedure in After working inside your computer.
Rear-NVMe module
Removing the Rear-NVMe module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the external solid-state drive assembly.
3. Remove the right-side cover.
About this task
The following images indicate the location of the rear-NVMe module and provide a visual representation of the removal
procedure.
96
Removing and installing components
To Next Page
Loading...
