3. Remove the front system-fan assembly.
About this task
The following image provides a visual representation of the front system-fans removal procedure.
Steps
1. Unroute the fan cable from the routing clip on the fan bracket.
2. Move the fan at an angle from the fan bracket.
3. Remove the fan cable from the slot on the bracket.
4. Lift and remove the fan along with the cable away from the fan bracket.
NOTE: Perform step 1 to step 3, to remove rest of the fans from the fan bracket.
Installing the front system-fans
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image provides a visual representation of the front system-fans installation procedure.
Steps
1. Insert the fan cable into the slot on the fan bracket.
2. Align and place the fan at an angle into the slot in the fan bracket.
3. Route the fan cable through the routing clip on the fan bracket.
NOTE: Perform step 1 to step 3, to install rest of the fans into the fan bracket.
Next steps
1. Install the front system-fan assembly.
Removing and installing components
65
To Next Page
Loading...
