About this task
The following images indicate the location of the front I/O-board and provide a visual representation of the removal procedure.
Steps
1. Disconnect all the cables from the connectors on the front I/O-board.
2. Loosen the thumb screw on the front I/O-bracket and unscrew it until the front I/O-bracket is free to move.
3. Move the top end of the front I/O-bracket at an angle to free it from its slot on the chassis.
4. Remove the front I/O-bracket from the computer.
5. Remove the three (6-32) screws that secure the front I/O-bracket to the front I/O-board.
Slide the front I/O-board to remove it from the front I/O-bracket.
Installing the front I/O-board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
25
To Next Page
Loading...
