2. Remove the left-side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the non-powered graphics card and provide a visual representation of the removal
procedure.
Steps
1. Lift the PCIe latch to open the PCIe door.
2. Lift the graphics card away from the graphics-card slot.
3. Align and place the PCIe filler into the PCIe slot.
4. Push the PCIe latch to close the PCIe door.
Installing the non-powered graphics card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
71
To Next Page
Loading...
