About this task
The following images indicate the location of the front I/O-bezel and provide a visual representation of the removal procedure.
Steps
1. Remove the single screw (M3) that secures the front I/O-bezel to the chassis.
2. Pry the retention tabs to release the front I/O-bezel from the chassis.
3. Slightly pull the front I/O-bezel to remove the front I/O-bezel from the computer.
Installing the front I/O-bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front I/O-bezel and provide a visual representation of the installation
procedure.
Removing and installing components
23
To Next Page
Loading...
