Steps
1. Slide and insert the 3.5-inch hard-drive assembly into the external flexbay slot.
2. Close the release latch to secure the 3.5-inch hard-drive assembly in place.
Next steps
1. Install the front hard-drive bezel.
2. Follow the procedure in After working inside your computer.
Removing the rear 2.5-inch hard-drive assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
About this task
The following images indicate the location of the rear 2.5-inch hard-drive assembly and provide a visual representation of the
removal procedure.
46
Removing and installing components
To Next Page
Loading...
