Steps
1. Align and place the rear memory-fan in the slot on the air shroud.
2. Route the rear memory-fan cable through the routing guides on the air shroud.
3. Connect the rear memory-fan cable to the DDR FAN1 dongle plug in the air shroud.
Next steps
1. Install the air shroud.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Memory modules
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the air shroud.
About this task
The following image indicates the location of the memory module and provide a visual representation of the removal procedure.
34
Removing and installing components
To Next Page
Loading...
