Front SATA/SAS module
Removing the front SATA/SAS module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the front 2.5-inch hard-drive assembly.
3. Remove the front 3.5-inch hard-drive assembly.
4. Remove the right-side cover.
About this task
The following images indicate the location of the front SATA/SAS module and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the thermal-sensor cables and fan-controller cables from the connectors on the power-distribution board.
Removing and installing components
99
To Next Page
Loading...
