Dell Precision 7960 Tower - Installing the Front Optical-Drive and Hard-Drive Bezel

Steps
1. Pry the retention tabs to release the front optical-drive and hard-drive bezel from the computer.
2. Slightly pull the front optical-drive and hard-drive bezel to release the bezel from the slots in the chassis.
3. Remove the front optical-drive and hard-drive bezel from the computer.
Installing the front optical-drive and hard-drive bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front optical-drive and hard-drive bezel and provide a visual representation of
the installation procedure.
18
Removing and installing components