Steps
1.
NOTE: Ensure that the four heat-sink clips are in the unlock position.
Align the screws on the processor fan and heat-sink assembly with the screw holders on the system board and place the
heat-sink assembly on the processor.
NOTE: Ensure that the triangle mark is directed towards the rear side of the computer.
2. Move the four heat-sink clips to the lock position.
3. In the sequential order (1->2->3->4), tighten the four captive (PEEK) nuts to secure the heat-sink assembly to the system
board.
NOTE: Tighten the screws in a sequential order (1,2,3,4) as printed on the system board.
Next steps
1. Install the air shroud.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the heat-sink assembly.
NOTE:
The processor might still be hot after the computer is shut down. Allow the processor to cool down before removing
it.
38 Removing and installing components
To Next Page
Loading...
