2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Installing the front system-fan assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front system-fan assembly and provide a visual representation of the
installation procedure.
Steps
1. Align the tabs on the front system-fan assembly with the slots on the chassis.
2. Insert the fan assembly at an angle into the slot in the chassis.
3. Tighten the two captive screws to secure the front system-fan assembly to the system-board tray.
4. Replace the three (6-32) screws to secure the front system-fan assembly to the chassis.
66
Removing and installing components
To Next Page
Loading...
