Steps
1. Disconnect all the cables from the connectors on the power-distribution board and unroute the cables from the routing
guides.
NOTE: Ensure to note the connectors from where the cables are being disconnected.
2. Disconnect the data cables and power cables from the connectors on the rear backplane and unroute the cables from the
routing guides on the power-distribution board.
3. Remove the four (6-32) screws that secure the power-distribution board to the chassis.
4. Lift the power-distribution board to remove it from the computer.
Installing the power-distribution board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
92
Removing and installing components
To Next Page
Loading...
