About this task
The following image indicates the location of the power-distribution board and provides a visual representation of the installation
procedure.
Steps
1. Align the screw holes on the power-distribution board with the screw holes on the chassis.
2. Replace the four (6-32) screws to secure the power-distribution board to the chassis.
3. Connect all the cables to their respective connectors on the power-distribution board and route the cables through the
routing guides.
4. Connect the data cables and power cables to the connectors on the rear backplane and route the cables through the routing
guides on the power-distribution board.
Next steps
1. Install the power-supply unit.
2. Install the right-side cover.
3. Follow the procedure in after working inside your computer.
Removing and installing components
93
To Next Page
Loading...
