Steps
1. Disconnect all the cables from the connectors on the front side of the system board.
2. Disconnect all the data cables from the connectors on the bottom side of the system board.
3. Remove the 13 (6-32) screws that secure the system board to the chassis.
4. Lift the system board at an angle and remove the system board off the chassis.
5. Remove the five (M3) screws that secure the bottom-air shroud to the system board.
6. Lift the bottom-air shroud away from the system board.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
112
Removing and installing components
To Next Page
Loading...
