Steps
1. Align the UltraSpeed Duo card with the expansion-card slot on the system board.
2. Remove the PCIe filler from the PCIe slot on the chassis.
3. Using the alignment post, connect the UltraSpeed Duo card to the connector and press down firmly. Ensure that the
UltraSpeed Duo card is firmly seated.
4. Close the PCIe door.
Next steps
1. Install the air shroud.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Removing the UltraSpeed Quad card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the UltraSpeed Quad card and provide a visual representation of the removal
procedure.
Removing and installing components
77
To Next Page
Loading...
