Steps
1. Disconnect the power cable and data cable from the connectors on the HSBP board.
2. Disconnect the thermal-sensor cable and fan-controller cable from the connectors on the power-distribution board.
3. Remove the two screws (6-32) that secure the rear-NVMe module to the flex4.
4. Lift and remove the rear-NVMe module away from the computer.
NOTE: Follow the same procedure to remove the rear-NVMe module from the flex3.
Installing the rear-NVMe module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the rear-NVMe module and provide a visual representation of the installation
procedure.
Removing and installing components
97
To Next Page
Loading...
