5. Connect the speaker cable to the speaker dongle-cable and route the speaker on the fan assembly.
6. Connect the fan cables to the connectors on the system board.
Next steps
1. Install the PCIe holder.
2. Install the air shroud.
3. Install the left-side cover.
4. Follow the procedure in After working inside your computer.
Rear fans
Removing the rear system-fan assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the rear system-fan assembly and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (6-32) screws that secure the fan assembly to the chassis.
2. Move the fan assembly at an angle from the chassis.
3. Disconnect the two fan cables from the connectors on the system board.
4. Lift and remove the fan assembly from the computer.
Removing and installing components
67
To Next Page
Loading...
