5. Slide the M.2 2280 solid-state drive into the M.2 2280 slot on the UltraSpeed Quad card.
6. Replace the screw (M2x3) that secures the M.2 2280 solid-state drive to the UltraSpeed Quad card.
7. Close the fan shroud and press until it clicks in place.
NOTE: The UltraSpeed Quad card supports four solid-state drives. Repeat step 1 to step 7 to install the solid-state drive
into the rest of the slots.
Next steps
1. Install the UltraSpeed Quad card.
2. Install the left-side cover.
3. Follow the procedure in after working inside your computer.
Installing the UltraSpeed Quad card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the UltraSpeed Quad card and provide a visual representation of the installation
procedure.
80
Removing and installing components
To Next Page
Loading...
