Steps
1. Pry the retention tabs to release the front optical-drive and hard-drive bezel from the computer.
2. Slightly move the front optical-drive and hard-drive inner bezel outwards to release the bezel from the slots on the chassis.
3. Remove the front optical-drive and hard-drive inner bezel from the computer.
Installing the front optical-drive and hard-drive inner bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front optical-drive and hard-drive inner bezel and provide a visual
representation of the installation procedure.
Steps
1. Position the front optical-drive and hard-drive inner bezel to align the tabs on the bezel with the slots on the chassis.
2. Press the bezel until the tabs clicks into the place.
Next steps
1. Install the right-side cover.
2. Follow the procedure in After working inside your computer.
20
Removing and installing components
To Next Page
Loading...
