Steps
1. Using a Torx T30 screwdriver, in reverse sequential order (4->3->2->1), loosen the four captive (PEEK) nuts that secure the
heat-sink assembly to the system board.
2. Move the four heat-sink clips to the unlock position.
3. Lift the heat-sink assembly from the system board.
Installing the heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that
thermal conductivity is achieved.
About this task
The following images indicate the location of the heat-sink assembly and provides a visual representation of the installation
procedure.
Removing and installing components
37
To Next Page
Loading...
