Dell Precision 7960 Tower - Installing the Pcie Holder

2. Remove the left-side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the PCIe holder and provide a visual representation of the removal procedure.
Steps
1. Open the PCIe-holder press cover and unroute all the VGA cables from the routing guides.
2. Close the PCIe-holder press cover.
3. Release the clips that secure the PCIe holder to the chassis.
Installing the PCIe holder
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the PCIe holder and provide a visual representation of the installation procedure.
62
Removing and installing components