Steps
1. Disconnect the front memory-fan cable from the DDR FAN0 dongle plug in the air shroud.
2. Unroute the front memory-fan cable from the routing guide on the air shroud.
3. Push and hold the releasing clip on both the sides of the front memory-fan to release the fan from the slot.
4. Lift the front memory-fan away from the air shroud.
Installing the front memory-fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front memory-fan and provide a visual representation of the installation
procedure.
Removing and installing components
31
To Next Page
Loading...
