Dell Precision 7960 Tower - Rear SATA;SAS Module; Removing the Rear SATA;SAS Module

3. Install the four screws (6-32) to secure the front SATA/SAS modules to the flex0 and flex1.
4. Connect the slimline MegaRAID cable to the connector on the MegaRAID card.
5. Connect the power cable to the dongle cable.
6. Connect the thermal-sensor cables and fan-controller cables to the connectors on the power-distribution board.
Next steps
1. Install the right-side cover.
2. Install the front 3.5-inch hard-drive assembly.
3. Install the front 2.5-inch hard-drive assembly.
4. Follow the procedure in After working inside your computer.
Rear SATA/SAS module
Removing the rear SATA/SAS module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the rear 2.5-inch hard-drive assembly.
3. Remove the rear 3.5-inch hard-drive assembly.
4. Remove the right-side cover.
About this task
The following images indicate the location of the rear SATA/SAS module and provide a visual representation of the removal
procedure.
Removing and installing components
101