Steps
1. Disconnect the thermal-sensor cables and fan-controller cables from the connectors on the power-distribution board.
2. Disconnect the SATA data cable from the connector on the system board.
3. Disconnect the power cable from the dongle-cable.
4. Unroute the data and power cables from the clip on the chassis.
5. Remove the four screws (6-32) that secure the front SATA hard-drive modules to the flex0 and flex1.
6. Lift and remove the front SATA hard-drive modules away from the flex0 and flex1.
Installing the front SATA hard-drive modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front SATA hard-drive module and provide a visual representation of the
installation procedure.
Removing and installing components 105
To Next Page
Loading...
