Steps
1. Align the screw holes on the front SATA hard-drive modules with the screw holes on the flex0 and flex1.
2. Place the front SATA hard-drive module into the slot in the flex0 and flex1.
3. Install the four screws (6-32) to secure the front SATA hard-drive modules to the flex0 and flex1.
4. Route the power and data cable through the clip on the chassis.
5. Connect the SATA data cable to the connector on the system board.
6. Connect the power cable to the dongle-cable.
7. Connect the thermal-sensor cables and fan-controller cables to the connectors on the power-distribution board.
Next steps
1. Install the right-side cover.
2. Install the front 3.5-inch hard-drive assembly.
3. Install the front 2.5-inch hard-drive assembly.
4. Follow the procedure in After working inside your computer.
106 Removing and installing components
To Next Page
Loading...
