Installing the wireless card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the wireless card and provide a visual representation of the installation procedure.
Steps
1. Align and slide the PCIe riser card into the expansion-card slot on the system board.
2. Connect the PCIe riser-card cable to the connector on system board.
3. Route the PCIe riser-card cable through the hook on the chassis.
4. Close the PCIe door.
Next steps
1. Install the air shroud.
2. Install the left-side cover.
Removing and installing components
85
To Next Page
Loading...
