Dell Precision 7960 Tower - Front I;O-Board; Removing the Front I;O-Board

Steps
1. Position the front I/O-bezel to align the tabs on the bezel with the slots on the chassis.
2. Replace the single screw (M3) to secure the front I/O-bezel with the chassis.
Next steps
1. Install the top cover.
2. Install the front optical-drive and hard-drive bezel.
3. Install the front bezel.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Front I/O-board
Removing the front I/O-board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front bezel.
4. Remove the front optical-drive and hard-drive bezel.
5. Remove the top cover.
6. Remove the front I/O-bezel.
7. Remove the right-side cover.
8. Remove the air shroud.
9. Remove the front optical-drive and hard-drive inner bezel.
10. Remove the PCIe holder.
11. Remove the front system-fan assembly.
24
Removing and installing components