About this task
The following images indicate the location of the processor and provide a visual representation of the removal procedure.
Steps
1. Using the four keying latches on processor carrier, remove the processor carrier from the heat-sink assembly.
2. Press the release lever down and then extend the release lever completely to release the processor from processor carrier.
CAUTION:
When removing the processor, do not touch any of the pins inside the socket or allow any objects
to fall on the pins in the socket.
3. Gently slide the processor out of the processor carrier.
Installing the processor
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
39
To Next Page
Loading...
