6. Install the front I/O-bezel.
7. Install the top cover.
8. Install the front optical-drive and hard-drive bezel.
9. Install the front bezel.
10. Install the left-side cover.
11. Follow the procedure in After working inside your computer.
Rear bezel
Removing the rear hard-drive bezel
Prerequisites
1. Follow the procedure in Before working inside your computer.
About this task
The following images indicate the location of the rear hard-drive bezel and provide a visual representation of the removal
procedure.
Steps
1. Slide down the release latch to unlock the bezel from the chassis.
2. Slightly pull the rear hard-drive bezel to release the bezel from the slots in the chassis.
3. Remove the rear hard-drive bezel from the computer.
Installing the rear hard-drive bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
27
To Next Page
Loading...
